Yard-man 549 Manuel d'utilisateur télécharger pdf (Page 8)

• Fasten the cable to the lower handle with the two

cable ties found on the lower handle. Pull the cable

ties tight and trim off the excess. See Figure 5.

Figure 5

NOTE: Your mower is shipped with the handle in the

higher position. If you wish to lower the height of the

handle, refer to the Adjustment Section at this time.

Attaching Rear Wheels

• Remove the hex flanged nut on the rear axle from

each side (leave the spring washer in place) and

place the rear wheel on the axle. See Figure 6.

Reinsert the flanged nut into the axle as shown,

and tighten securely. Repeat on other side.

Figure 6

Attaching Starter Rope

The rope guide is already attached to the right side of

the upper handle of your mower. See Figure 7.

Figure 7

• With the spark plug wire disconnected and

grounded, hold the blade control handle against the

upper handle, and pull the rope out of the engine.

• Slip the rope through the rope guide as shown

below. Tighten the wing nut holding the rope guide

to the upper handle.

Assembling Grass Catcher

NOTE: If the grass catcher came pre-assembled,

proceed to the next section. If it came unassembled,

follow the steps below to assemble it first, before

attaching to the mower.

• Insert frame into grass bag with the black plastic

side on the bottom of bag. See Figure 8.

• Slip the openings in the side of the plastic channel

on bag over the hooks on the grass catcher frame.

Secure bag to the frame by working the six plastic

channels on bag over frame. All of the plastic chan-

nels except the center top of the bag attach from

the outside of bag. The center top of the bag

attaches from inside the bag. See Figure 8.

Figure 8

Attaching Hard Top Cover (If Equipped)

• Slide the hardtop cover under the grass catcher

handle, positioning it so the handle rests snugly into

the notch in the cover, and press the frame into the

tabs at the back of the cover. See Figure 9 .

Figure 9

• Position the mounting bracket facing down

between the front of the handle and the front of the

Cable Tie

Lower

Handle

Hex

Nut

Rear Axle

Rear Wheel

Spring

Washer

Wing Nut

Starter Rope

Rope Guide

Upper Handle

Lower Handle

Grass Catcher

Frame

Insert frame

into bag

Grass Bag

Plastic

Channel

Grass Catcher

Assembly

Complete

Self Tapping

Grass

Catcher

Handle

Screws

Notch in

Hardtop

Cover

Mounting

Bracket

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire

Yard-man 549 Manuel d'utilisateur Page 8

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel de jardinage Yard-man 549